Base
Full Name | Arpita Singh |
Organization | RTU, Kota |
Job Title | Student |
Country |
Forum Replies Created
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
So, can we use the laser array for spectrum slicing?
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
Greetings Sir
Thanks a ton for replying. My design needs 7 iteratons. I have got the results and the components are working properly but the problem relies on:
1. I am not getting the exact output as the reference paper.
2. The parameters put in Dynamic Y Select used in the onu (of business, building, school mall and residence) are correct according to my design or not.
3. Can I replace 1*N splitter with WDM mux-demux splitter in the subsystems because i am getting better results then.
I’ll be highly grateful on being enlighten on this further.
Thanking you
Arpita Singh
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
Hello Cem,
Thanks a ton for the reply. I’ll seek to your suggestion and let you know the results soon.
Regards.
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
This is my design. please go through it and suggest how can i improve.
N*1 bidirectional splitter in wdm pon architecture
Can someone please tell me why is my design not showing the output. I think the problem is with the bidirectional splitter I have used. I need to implement it in order to work further in the field. Attaching it below. Regards.
My design has run after I have replaced the n*1 bidirectional splitter with wdm mux-demux in the design. Have not got the desired output yet +but better than nothing. Will somebody please tell me how to implement it properly and why has the bidirectional splitter not worked. Attaching the new work. Regards.
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
Thank you very much, Sir. I have been able to upload my work now. Very grateful to both of you for your reply.
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
I am also facing a problem with bidirectional splitter. In my case I am not getting an output after the splitter.
I am attaching an image of the same. Any help will be appreciated.
Attachments:
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/24500/59bbcb4fba91b-bpfull.jpg)
The respective design is attached below.Pardon me,and please reply.Regards.