Base
Full Name | Metin Ozturk |
Organization | Yıldırım Beyazıt University |
Job Title | Research Assistant |
Country |
Forum Replies Created
I have solved the problem.
“Convert Noise Bins” was not activated.
Thank you.
I saw that it is not about OFDM.
Then, what can be the problem?
Hi.
When we perform multi-itaration, we do not change any parameter. So, SNR, BER, and OSNR values are very close for each iterations.
In my opinion, this does not make any sense.
How can we plot BER/SNR graph?
Regards.
Thank you for your interest.
When I change the CW Laser power to 50 dBm, desirable results obtained. But, I do not know, 50 dBm power for laser is OK or not?
I really thank you for your help.
I attached the file. Channel and CW Laser are changed.
Thank you again.
Thank you for your answers.
Alitsu, that system is working well, but when i change the CW Laser parameters as Frequency=550 nm and Linewidth=300 GHz to cover whole visible range, results get worse. Do you have any idea aout this?
Thank you.
Hello Damian.
Your file 64QAM OFDM is OK, but when I change the parameters of CW Laser to the Visible Light conditions such as Frequency=550 nm and Linewidth=300 GHz, BER becomes unaccaptalbe. I choose those parameters to cover whole visible range like white light.
Thank you.
Best Regards.
I attached my system file.
Could you please help me regarding DSP block?
Thanks.
Hi Sam.
Thank you for your answer.
Could you please help me inserting DSP to my system?
How can I do this?
Thanks.
Also, my screenshots are in the attachment.
Thank you for your valuable help.
Dear Ravil and Sam Sung.
I attached my file. In this file, i tried to re-arrange an optisystem example from this website.
My problems:
1) I cannot LED as a light source. Also, I cannot use laser for visible range. Both of them gives no result or bad results.
2) In this file, if i use 4-QAM, there is no problem. But, if I use 16-QAM, i cannot get acceptable results.
Thank you.
Regards.
Thank you Bryan.
I have just send an e-mail.