Forum Replies Created

    #48804
    Profile Photo
    sara fettach
    Participant

    please i have another question,
    i’ve realised a transmission co-ofdm with 4qam and as results , for 30Gbits the value of the Q factor is 6.37e12 and BER = 0
    and when i change the bits rate to 35Gbits/s, the value of the Q factor became 27.84 and BER 3.2e-4
    are these values correct ?
    thank you

    #48803
    Profile Photo
    sara fettach
    Participant

    thank you so much

    #48518
    Profile Photo
    sara fettach
    Participant

    thank you so much

    #47513
    Profile Photo
    sara fettach
    Participant

    this happens also with the other projects

    #47508
    Profile Photo
    sara fettach
    Participant

    and recently , even if I change the parameters of my work, (bit rate or the length of the fiber) the BER is always at 0 and the Q factor at 5.05 e49, it is as if the program was stuck in this value, and suddenly it stops working, should i uninstal and reinstall the program? if i uninstal it, is there a probability that i lose my data?

    #47507
    Profile Photo
    sara fettach
    Participant

    thank you for your answer
    for all the project , i work with optisystem v13

    #47482
    Profile Photo
    sara fettach
    Participant

    hello NURUL HAMIDA,
    all channels are designed to have the same parameters except for the frequence of the laser, for exemple for the first channel i give it 193.05 THz , the second 193.1THz, the third 193.15..
    NB: sorry for my english

    #47068
    Profile Photo
    sara fettach
    Participant

    Hello ,
    I would like to do a co-ofdm simulation with 4 channels, each transmit 10gbps, multiplexed with WDM, and with a single mode fiber of a length of 60km, as a result I notice that the BER is 0.48. is it normal ? and what value should i change to decrease the BER?
    please i need help
    Thank you

    #47060
    Profile Photo
    sara fettach
    Participant

    there is an error of uploading the file , can i send it to you via e-mail ?

    #47049
    Profile Photo
    sara fettach
    Participant

    hello;
    I have the same problem as @gabby , i’m doing simulation about coherent optical ofdm, and the value of BER is very bad about 0.48, i dont know which value i should change, please help me , Here is my file
    I’m working with optisystem v 13
    BEST REGARDS

    #45311
    Profile Photo
    sara fettach
    Participant

    s.fettach@gmail.com

    Thank you so much