Forum Replies Created

    March 13, 2015 at 9:43 am #18631
    Profile Photo
    Liang Yang
    Participant

    By the way, could you tell the bias current/bias amplitude for the RSOA, because from your examples RSOA_Modulator and RSOA_DownstreamTransmission, NRZs amplitute are set as 1/0 and 0.06/0.036 in Max/Min mode, respectively. On which amplitude of NRZ, this RSOA can be triggered.

    March 13, 2015 at 9:00 am #18626
    Profile Photo
    Liang Yang
    Participant

    Thank you! Damian.

    Do you get any result in Slope responsibity? I get nothing in this graph. As mentioned in your tutorial, it has to be a curve as shown in attachment.

    March 12, 2015 at 11:06 am #18578
    Profile Photo
    Liang Yang
    Participant

    Thanks for your reply.

    Enclosed is setup for my simulation to getting to know how to use this visualizer and measure the bandwidth of RSOA.

    I give an electrical signal to directly modulate the RSOA at 1GHz and 2GHz. So i set the start frequency and stop frequency at 1 GHz and 2 GHz, use an E-O operation. I meanwhile set the iteration in global parameter to 2 as you said. But i am not sure the bitrate here in global parameters is 1 or 2? Or arbitrary value since the operation frequency is managed by start/stop frequency rather than this parameter?

    I think i have correctly connect all the components but the result seems…

    So could you help me in this example?

    March 11, 2015 at 9:14 am #18512
    Profile Photo
    Liang Yang
    Participant

    My version is 13, is there tutorial shows how to connect the six ports. By the way, as mentioned in new features of optisystem 13.0, a new visualizer-Lightwave Analyzer are added into the library. So the same problem, how to use it. Actually, i want measure the bandwidth of RSOA, can this visualizer be involved?