[ferasParticipant]

.

[ferasParticipant]

hi mohamed diaa
really i don not know how to solve this problem

[ferasParticipant]

i can not attached my file
i get this error msg ” Sorry, this file type is not permitted for security reasons. “

[ferasParticipant]

hello Cem,
thank you for your interested
actually in my design i can get the signal now in the downlink direction but i have a problem in the up link signal where i can not get clear signal
this is my design and i hope you will help me
thank you alot

[ferasParticipant]

hi love kumar
i found it and try it and nothing different happens.

[ferasParticipant]

hello Ranjeet,
the problem is very clear and its :
the RF spectrum analyzer and electrical carrier analyzer did not give the same value for signal power as the pic show.
Regards

[ferasParticipant]

hello love kumar .,
thank you for your interested , but what is the pan option ? and where can i find and use it ?
Regards.

[ferasParticipant]

hello Fayiqz,
thank you for your interested
actually i used electrical power meter and its result was more closer to the electrical carrier analyzer results
but the question is how can we get the same results and why this happened
thank you again for your helping

[ferasParticipant]

any help please

[ferasParticipant]

dear damian , hello
can you please answer me on mu post https://optiwave.com/forums/topic/use-of-the-matlab-component-optical-system/#post-28929
i am really need a clear answer if you can
Regards

[ferasParticipant]

you are welcome alistu
Regards.

[ferasParticipant]

hello alistu, you are welcome
i attached you what it is in “About OptiSystem”, it is optisystem 14.0 64-bit

[ferasParticipant]

i installed it and it is run a 30-days trial optisystem 14 64-bit , and run well .
there is some additional component in , you can try to use it if you want without any risk.
Regards.

[ferasParticipant]

hi mohamed,
actually alistu is right in every word he typed hhhh
thank you all
Regards.

[ferasParticipant]

hello,
i am using optisystem 13 32-bit to design OFDM radio over fiber system that carried LTE signal over fiber optic channel and i am facing aproblem in getting a big BER value ( 0.33 ) and low Q factor but clear constellation diagram , even when run the simulation without any fiber channel (( only modulate and demodulate )) it still give me the same BER value without any change , i hope you to give me the reason why that happened and how can i get the right BER that depending to the channel .
thank you very much