- This topic has 3 replies, 2 voices, and was last updated 1 year, 3 months ago by
Sawyer Ge.
-
AuthorPosts
-
-
June 11, 2022 at 7:10 am #79862
lanalayaq
Memberhello everyone how the component will be connected with 4 channel WDM-ROf to calculate the attenuation
or the gain in order to get the desired Q factor or minimize the BER by optimizing the fiber
length of the system.with regards
-
June 30, 2022 at 12:21 pm #80785
Ahmad Atieh
ModeratorHello,
Is it possible to elaborate on your enquiry? the question is not clear. It would be helpful if you add a diagram to show where you’d like to measure the attenuation or gain?
There are couple of visualizers (WDM Analyzer & Electrical Carrier Analyzer) in OptiSystem that can be used to monitor the signals in the optical and electrical domains and calculate the gain/loss.
Regards,
Ahmad -
June 30, 2022 at 12:21 pm #83389
Ahmad Atieh
ModeratorHello,
Is it possible to elaborate on your enquiry? the question is not clear. It would be helpful if you add a diagram to show where you’d like to measure the attenuation or gain?
There are couple of visualizers (WDM Analyzer & Electrical Carrier Analyzer) in OptiSystem that can be used to monitor the signals in the optical and electrical domains and calculate the gain/loss.
Regards,
Ahmad -
June 30, 2022 at 8:06 pm #80793
Veronique Shuster
Membersorry dear dr Ahmad Atieh, my question is all about SPO optimization, how the procedure will be done in the optisystem for a specific system e.g to optimize the length of the optical fiber for achieving a better BER or Quality factor.
with regards
Lana -
June 30, 2022 at 8:06 pm #83397
Veronique Shuster
Membersorry dear dr Ahmad Atieh, my question is all about SPO optimization, how the procedure will be done in the optisystem for a specific system e.g to optimize the length of the optical fiber for achieving a better BER or Quality factor.
with regards
Lana -
July 4, 2022 at 11:11 am #80795
Ahmad Atieh
ModeratorDear Lana,
you may use the optimization feature in OptiSystem. You could setup the optimization for the length of the fiber for a criteria of Q-factor or min BER.
Please check the examples on optimization in OptiSystem Example Library. Also, you may check the attached publication on the optimization topic.
Regards,
Ahmad -
July 4, 2022 at 11:11 am #83399
Ahmad Atieh
ModeratorDear Lana,
you may use the optimization feature in OptiSystem. You could setup the optimization for the length of the fiber for a criteria of Q-factor or min BER.
Please check the examples on optimization in OptiSystem Example Library. Also, you may check the attached publication on the optimization topic.
Regards,
Ahmad
-
-
AuthorPosts
- You must be logged in to reply to this topic.