- This topic has 4 replies, 3 voices, and was last updated 10 years, 1 month ago by .
Viewing 3 reply threads
Viewing 3 reply threads
- You must be logged in to reply to this topic.
Optiwave software can be used in different industries and applications, including Fiber Optic Communication, Sensing, Pharma/Bio, Military & Satcom, Test & Measurement, Fundamental Research, Solar Panels, Components / Devices, etc..
Download our 30-day Free Evaluations, lab assignments, and other freeware here.Â
Optiwave software can be used in different industries and applications, including Fiber Optic Communication, Sensing, Pharma/Bio, Military & Satcom, Test & Measurement, Fundamental Research, Solar Panels, Components / Devices, etc..
Download our 30-day Free Evaluations, lab assignments, and other freeware here.Â
If I have a design and I need to measure the effect of transmitted power on BER,How I can run Optisystem to Change Transmitted power and run the design then record the results automatically for different values of transmitted power without my intervention.
This is possible in using the Sweep mode. By changing the power parameter for the transmitter it is possible to run the simulation multiple times and record the results.
Here is a tutorial on this subject:
Regards
Manually takes too much power and BER value recording, the beManually takes too much power and BER value recording, the best way to do is sweep parameters in case power vs BER.st way to do is sweep parameters in case BER vs power.
The results appear as small point that may be unreadable,How can make it large marks like matlab.
You can change the chart properties by left clicking the small blue icon at the top left of the chart and heading to the Properties tab.