MAtlab Electrical Component
Hi all,
I am trying to find the signal to noise ratio of the output of a photonically sampled ADC. For the SNR calculation I have used a matlab component. The project gives SNR value at the output but the problem is that each time I rerun the project, the value of SNR differs by a small amount.
Can anyone suggest what is the problem with the simulation.
I am also attaching the osd and matlab file.
Responses (4):
-
Hi all,
I am trying to find the signal to noise ratio of the output of a photonically sampled ADC. For the SNR calculation I have used a matlab component. The project gives SNR value at the output but the problem is that each time I rerun the project, the value of SNR differs by a small amount.
Can anyone suggest what is the problem with the simulation.
I am also attaching the osd and matlab file. -
The matlab file
-
you have posted same topic in other post of yours
let be it only one post as discussion on only one post will lead to faith full conclusion.
with regards
-
Yes, that was done by mistake. I tried deleting that post, but was unable to do so.
Sorry for inconvinience -
it happen some time dont wory jamal
regards
Login You must be logged in to reply to this topic.