Photonic Software

Home › Forums › FIBER › load insertion loss for isolatior

load insertion loss for isolatior

Profile Photo
Xin Huang
(joined June 2021)
Participant

Hi,

I am using Optisystem to calculate YDFA. The insertion loss of my Isolator is wavelength dependent. Could you tell me how to load wavelength dependent insertion loss for Isolator in Optisystem?

Responses (1):

    • May 5, 2022 at 6:42 am #70717
      Profile Photo
      Xin Huang
      Participant

      Hi,

      I am using Optisystem to calculate YDFA. The insertion loss of my Isolator is wavelength dependent. Could you tell me how to load wavelength dependent insertion loss for Isolator in Optisystem?

    • May 10, 2022 at 7:30 am #70724
      Profile Photo
      Ahmad Atieh
      Moderator

      Dear Xin,
      you should be able to setup the wavelength dependent isolation of the Isolator Bidirectional component as shown in the attached file. There are two options that could be used. I hope these options meet your needs. Else, please email me at ahmad.atieh@optiwave.com to discuss further.
      Regards,
      Ahmad

      Attachments:

      1. isolator-wavelength-dependent-settings.png

Login You must be logged in to reply to this topic.