Extract Data

[KumarParticipant]

Greetings!!!

Is it possible to extract the entire sweep data into an excel sheet instead of copying each iteration from Optisystem 17?

[Ahmad AtiehModerator]

Hello,
In OptiSystem version 17.1, you should be able to save the results of any component that offers results (when select the desired result in the component popup window) for every sweep as well as saving the component parameters when selected in the component properties popup window. You need to select save in the project layout. Please check the release note of OptiSystem 17.1 for more information.
Regards,
Ahmad

+1

[KumarParticipant]

Thank you sir for your valuable suggestions…. It has been very helpful for export the entire layout data. However, How to select particular component parameters for each iteration. if possible kindly give the tutorial or link for the same. Thanks in advance.

[Ahmad AtiehModerator]

Dear Kumar,
please make sure that you have OptiSystem version 17.1 to save results after each sweep iteration or at the end of calculation in a file for each layout. A scroll down option to choose between the two cases is available in the project layout properties popup window. you can save components results and selected components parameters as shown in the images attached.
There is a “ResultsData” directory in OptiSystem Example Library to allow saving the results into a file (Layout 1_ExportResults.dat). If the you do not install OptiSystem Example Library, then the saved results data file is placed at the default directory “ResultsData” located at the following link: C:\Users\USER NAME\AppData\Local\Temp\
Regards,
Ahmad

Attachments:

1. 

   saved-results-and-parameters-output.png
   

2. 

   selcted-component-parameters.png
   

3. 

   selected-results-of-pin-detector.png
   

4. 

   save-results-setup-in-project-layout.png
   

[KumarParticipant]

Thank you so much for your clarifications.