Home Forums GENERAL Electrooptic modulator and SOA modulation signals

Viewing 1 reply thread
  • Author
    Posts
    • #49912
      shaymaa Tahhan
      Participant

      Dear All,
      Thank you for reading my request.

      How to simulate the highlighted parts in optisystem could anybody help me and send me a picture of optisystem layout of only the highlighted parts please?

      your prompt reply will highly appreciated.

      Shaymaa

    • #49921

      Hi Shaymaa,

      there is component named SOA, that can be used.

      CW Laser diode could be used for your block High-Speed LD”.

      for EOM, there are different modulators that could be used like “AM”, “Mach-Zehnder Modulator”, “Burst Modulator” and other modulators. you can use one of them based on the required output of the block diagram.

      For the digital delay generator, there are three delay components “Binary Delay”, “Optical Delay”, and “Electrical Delay”. you can uses one of them based on your design. I mean, based on the type of the signal that you will delay you can use the suitable one of them.

      For the Pattern generator, you can either use “User Defined Bit Sequence Generator” if you want to generate specific pattern or use “Pseudo-Random Bit Sequence Generator” for random bits generation.

      So all blocks exist in OptiSystem to be used to build your system.
      Hope that helps.
      let us know if you have any other comments.
      best of luck.

      Mohamed Abouseif

Viewing 1 reply thread
  • You must be logged in to reply to this topic.