- This topic has 9 replies, 3 voices, and was last updated 8 years, 11 months ago by
Damian Marek.
-
AuthorPosts
-
-
April 19, 2014 at 5:12 am #10741
siva rama krishna
ParticipantHi,
How to generate Quadrature Dual Polarization-Duobinary signal? If any one generated please provide the details.
Please provide the snapshot of circuit diagram. -
April 22, 2014 at 4:26 pm #10826
Tech Support
Participant -
April 22, 2014 at 4:26 pm #10828
Tech Support
ParticipantSince the DSP for Duobinary modulation format hasn’t been finished yet, the DSP and BER measurement parts have to be built using our Matlab component.
-
April 26, 2014 at 1:31 pm #11107
siva rama krishna
ParticipantMine is lower version of Optisystem.So please provide Circuit diagram and important parameters in image format.
-
April 28, 2014 at 1:15 pm #11159
Damian Marek
ParticipantAttached is a picture of a Duobinary dual polarization system.
Attachments:
-
-
October 30, 2014 at 2:37 pm #14711
siva rama krishna
ParticipantHi,
How to generate DP-QDB(Dual Polarization Quadrature Duobinary) Modulation?
(Above attached paper is about DP-DB but to get DP-QDB, 90 degree phase shifter has to be added after one of MZM and before Power combiner.If i am going wrong on this method please correct me)
How to get Constellation diagram as shown in the attached paper?Please provide me assistance.
-
November 5, 2014 at 4:25 pm #14958
Damian Marek
Participant
-
-
November 5, 2014 at 6:16 am #14920
siva rama krishna
ParticipantPlease reply
-
November 6, 2014 at 8:18 am #14995
siva rama krishna
ParticipantThank you damian for your reply.
Got the constellation diagram what i am expecting.
What ever i mentioned method in previous post for DP-QDB generation(90 degree phase shifter has to be added after one of MZM and before Power combiner) is correct or not?Please provide your feedback.
Thanks and Regards
Siva Rama Krishna-
November 6, 2014 at 10:19 am #15009
Damian Marek
ParticipantThere is a 90 degree phase shift in the X coupler which generates the two optical signals. The second output port is always 90 degrees out of phase with the first output port, so it should not be necessary.
-
-
-
AuthorPosts
- You must be logged in to reply to this topic.