BER Analyzer shows Eye Diagram but Q Factor and BER values are zero in OptiSyste

[Safwan Mohammed Othman Masoud]

Analyzer displays the eye diagram correctly, but the calculated parameters are all zero.

The results are:

Max. Q Factor = 0
Min. BER = 1
Eye Height = 0
Threshold = 0
Decision Instant = 0

Although the eye diagram is visible, the BER Analyzer does not calculate the performance parameters.

What could be the reason for this issue?
Is it related to the input signal type, the connection to the BER Analyzer, the simulation parameters (bit rate, sequence length, samples per bit), or a missing setting in the BER Analyzer?

I would appreciate any suggestions or troubleshooting steps.

[Saurabh Bedi]

Hello Safwan,

In order to proceed further and provide you with the most relevant information and support, I would appreciate it if you could share a few additional details about yourself:
• University/Company:
• Job Title:
• University/Company Email:
• Phone Number:
This will help us better understand your needs and ensure we offer the best possible solution for you.

Also, please share your license serial number of OptiSystem?

Please share all the above information at support@optiwave.com

Warm Regards,
Saurabh Bedi.

[Author]

Posts