Home › Forums › FIBER › load insertion loss for isolatior › Reply To: load insertion loss for isolatior
May 10, 2022 at 11:30 am
#83313
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/23679/59945663b4165-bpfull.jpg)
Dear Xin,
you should be able to setup the wavelength dependent isolation of the Isolator Bidirectional component as shown in the attached file. There are two options that could be used. I hope these options meet your needs. Else, please email me at ahmad.atieh@optiwave.com to discuss further.
Regards,
Ahmad
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)