Home › Forums › EXCHANGE › Optisystem visualizer shows another time range › Reply To: Optisystem visualizer shows another time range
May 29, 2018 at 12:31 pm
#48915
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/30731/5acca06aa831e-bpfull.jpg)
Sir, as I confronted another problem that there didn’t find any variation in the output spectrum due to low frequency signals(vibration), I was unable to proceed with Optisystem. Can’t detect any changes that sine wave signals in the kHz range make to the light wave.(I have asked about this problem in another question in the forum;couldn’t get a reply) . Sir, isn’t low frequency detection possible in Optisystem?
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)