Home › Forums › SYSTEM › calculation time › Reply To: calculation time
September 11, 2015 at 2:58 am
#24579

If you are using hybrid optical amplifir than i would kike to suggest you following points
1. If you realized HOA correctly then as far as i read ,maximum gain is at -26 input power.That worked for me every time.In turn your calculation time reduce to much extent
2 Share your setup then i will try to modify it in same version you are using .
3. As power you used high in pump ,this will provide more gain it is not nessesity.Even by residual pumping at low pump power you xan get good gain with less noise figure.
4. Try to decrease the fiber length ,nore the fiber length more the calculation time.
These all problems may be corrected if you share the setup..
Thank you
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)