- This topic has 3 replies, 2 voices, and was last updated 2 years ago by
Sawyer Ge.
-
AuthorPosts
-
-
January 1, 1970 at 12:00 am #80851
Meagan Strahan
Member(Awaiting moderation)
-
January 1, 1970 at 12:00 am #83455
Meagan Strahan
Member(Awaiting moderation)
-
August 2, 2022 at 10:33 am #79877
Samuel Ribeiro
MemberHello!
I’m trying to simulate a single longitudinal mode operation using compound ring cavity laser based on cascaded fiber rings (compler + fiber) but the spectrum is not the expected. Firstly, I tried to build just a simple loop with amplifier + fiber + ring controller but it doesn’t work.
Do you know if it’s possible to simulate these behaviors in Optisystem? If positive, there’s any example?
Thanks for your attention! -
August 3, 2022 at 11:40 am #80829
Ahmad Atieh
ModeratorDear Samuel,
you need to make sure that you set the Iterations parameter in the Signals tab of the Layout Parameters window to 25 or higher number to allow light to circulate inside the cavity to produce the laser. Please check the examples in OptiSystem Example library located at the following link for more information.
C:UsersUSER NAMEDocumentsOptiSystem 19.0 SamplesOptical amplifiersFiber lasers and amplifiersregards,
Ahmad -
August 3, 2022 at 11:40 am #83433
Ahmad Atieh
ModeratorDear Samuel,
you need to make sure that you set the Iterations parameter in the Signals tab of the Layout Parameters window to 25 or higher number to allow light to circulate inside the cavity to produce the laser. Please check the examples in OptiSystem Example library located at the following link for more information.
C:UsersUSER NAMEDocumentsOptiSystem 19.0 SamplesOptical amplifiersFiber lasers and amplifiersregards,
Ahmad -
August 4, 2022 at 8:05 am #80831
Merry Ahrens
MemberHi Ahmad,
Thanks for your answer! I saw the exemples in OptiSystem library but I was trying to simulate the longitudinal modes as function of cavity (or fiber ring) size. Is it possible or is the best approach to use filter like the “Ring Laser” exemple?
Best regards,
Samuel. -
August 4, 2022 at 8:05 am #83435
Merry Ahrens
MemberHi Ahmad,
Thanks for your answer! I saw the exemples in OptiSystem library but I was trying to simulate the longitudinal modes as function of cavity (or fiber ring) size. Is it possible or is the best approach to use filter like the “Ring Laser” exemple?
Best regards,
Samuel. -
August 4, 2022 at 11:58 am #80833
Ahmad Atieh
ModeratorHello Samuel,
could you please email me at ahmad.atieh@optiwave.com to discuss further? I need to know the version of OptiSystem that you are using and your university name.
Regards,
Ahmad -
August 4, 2022 at 11:58 am #83437
Ahmad Atieh
ModeratorHello Samuel,
could you please email me at ahmad.atieh@optiwave.com to discuss further? I need to know the version of OptiSystem that you are using and your university name.
Regards,
Ahmad
-
-
AuthorPosts
- You must be logged in to reply to this topic.