Home Forums FIBER load insertion loss for isolatior

Viewing 2 reply threads
  • Author
    Posts
    • #79839
      Xin Huang
      Member

      Hi,

      I am using Optisystem to calculate YDFA. The insertion loss of my Isolator is wavelength dependent. Could you tell me how to load wavelength dependent insertion loss for Isolator in Optisystem?

    • #80709
      Ahmad Atieh
      Moderator

      Dear Xin,
      you should be able to setup the wavelength dependent isolation of the Isolator Bidirectional component as shown in the attached file. There are two options that could be used. I hope these options meet your needs. Else, please email me at ahmad.atieh@optiwave.com to discuss further.
      Regards,
      Ahmad

    • #83313
      Ahmad Atieh
      Moderator

      Dear Xin,
      you should be able to setup the wavelength dependent isolation of the Isolator Bidirectional component as shown in the attached file. There are two options that could be used. I hope these options meet your needs. Else, please email me at ahmad.atieh@optiwave.com to discuss further.
      Regards,
      Ahmad

Viewing 2 reply threads
  • You must be logged in to reply to this topic.