How to design a MATLAB code to run in optisystem? - Optiwave

Free Evaluation

This topic has 1 reply, 2 voices, and was last updated 6 years, 10 months ago by Ahmad Atieh.

Viewing 1 reply thread

Author

Posts
- February 19, 2019 at 6:40 am #50563
  
  Aishwarya Raj
  Participant
  
  Hello there. I wanted to ask that how should I design a MATLAB code so that I can interlink MATLAB and optisystem. When I tried the generate code option a code gets created automatically. But I am not getting how to make changes in the code to make it run for my use. Also,I have attached the circuit and where should I place the MATLAB component.
- February 19, 2019 at 1:43 pm #50598
  
  Ahmad Atieh
  Moderator
  
  Hello,
  Typically you need to write your Matlab code and link the file name to the proper field in the Matlab component in OptiSystem. However, you need to make sure that you define first the number of input and output ports of the Matlab component in OptiSystem and identify the type of signal (Optical, electrical, M-ary, binary) that you’ll deal with in your Matlab code. Finally, You need to structure the signal in the Matlab code properly following the instructions provided in the datasheet that can be accessed in the Help button in the Matlab component properties window in OptiSystem.
  You use also watch the relevant Optiwave’s webinars at the location below for more information.
  https://www.gotostage.com/channel/optiwave/
  Regards,
  Ahmad
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.