- This topic has 8 replies, 2 voices, and was last updated 9 years ago by
alistu.
-
AuthorPosts
-
-
November 19, 2015 at 10:56 pm #27950
Prarthana KashyapParticipantHi everyone,
What is the function of a low noise amplifier?
how does it works when it is used at the receiver input side?
what is the difference between Erbium doped fiber amplifier (EDFA) and low noise amplifier (LNA)?
Which component is there in optisystem V13 that can be used a a LNA?
I have found this topic on a research paper. which is used after the horn antenna as seen in the image attached. I think it is made in the MATLAB code. I have also attached here the paper. Thanks in advance.With Regards,
Prarthana -
November 19, 2015 at 10:58 pm #27952Prarthana KashyapParticipant
The Image snapshot is attached which is taken from the pdf itself. Thanks
Regards
-
November 19, 2015 at 11:31 pm #27957
alistuParticipantHi Prarthana,
In the attached image, after the optical signal passes photodiode and is therefore converted to electrical signal, it is transmitted and received by an antenna. So the LNA used must be electrical, and not optical according to the attached diagram. Can you please verify if I am right, or kindly correct me otherwise? (It is also mentioned in the text that the LO is electrical.)
Regards
-
-
November 19, 2015 at 11:00 pm #27954Prarthana KashyapParticipant
It is a humble request to optiwave team to add some of the Wireless feature in optisystem so that the design becomes easier for all of us. Thanking you.
Regards
-
November 20, 2015 at 1:46 pm #27972alistuParticipant
Generally (for electrical and optical signals), a LNA (or a low noise amplifier) is as its name implies any amplifier with low noise, and is usually used in receiver side in order to give better signal to the receiver for detection. So it has to do with noise figure in Optical amplifiers.
Regards
-
November 21, 2015 at 2:58 am #27976Prarthana KashyapParticipant
Hi Alistu, you have mentioned that
“a LNA (or a low noise amplifier) is as its name implies any amplifier with low noise and is usually used in receiver side in order to give better signal to the receiver for detection.” i.e. a amplifier that is of comparatively less noise,
but while googling i found a different concept “A Low-noise amplifier (LNA) is an electronic amplifier used to amplify very weak signals (for example, signals captured by an antenna). Essentially, an LNA amplifies signals that are barely recognizable without adding a lot of noise, as the name implies.”
you can have a look at https://en.wikipedia.org/wiki/Low-noise_amplifierit is basically used at the front-end of a radio receiver circuit.
Thanks for the reply.
regards
-
November 21, 2015 at 3:06 am #27979alistuParticipant
The definition you have mentioned has an orientation towards application of these amplifiers, whereas mine describes their characteristic. For amplifying weak signals (like the ones received by antennas), even smallest noise amounts can cause remarkable effect on the information, so these amplifiers are used for these purposes.
Regards
-
November 22, 2015 at 4:12 am #28004Prarthana KashyapParticipant
Thanks Alistu for the reply. I will look deep into this matter.
Regards
-
November 22, 2015 at 12:40 pm #28006alistuParticipant
You’re welcome Prarthana.
Regards
-
-
-
-
AuthorPosts
- You must be logged in to reply to this topic.