Home › Forums › SYSTEM › Why i am getting two eye diagrams for Gaussian Mono Cycle Pulse ? › Reply To: Why i am getting two eye diagrams for Gaussian Mono Cycle Pulse ?
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/570/f5a4d5f01c0ac61f82e9df3c934b3005-bpfull.jpg)
Thanks a lot Dear Jaffar for your kind response,
1. I am working in Uni-phase modulation format and u can verify it from the signal graph attached above (I am also attaching it below).
That’s the problem I don’t know why i am still getting two eye diagram ?
2. I’m using NRZ pulse generator and always work in On Off keying format (I am attaching project file where u can verify it)
Further, just for verification, Can u tell me how can I set On off keying in Opti sys 7 because there is no option about OOK modulation format in my setup.
3. As I could not get any solution to this problem so I decided to transmit only “Gaussian pulses” in UWB over fiber transmission instead of “Gaussian mono cycle pulse”, Is this right or wrong decision ?
4. I am searching different references where they have used Gaussian pulses in UWB over fiber transmission but could not find any good reference from reputable confreres/ journals like JLT, OFC etc.
Have u notice any work/research paper/ journal which had used Gaussian pulses in UWBoF transmission ?? kindly share it.
i am thankful to you for ur participation at post.
Best Regards
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)