Confinement loss in PCF - Optiwave

Free Evaluation

This topic has 1 reply, 2 voices, and was last updated 10 years, 5 months ago by Damian Marek.

Viewing 1 reply thread

Author

Posts
- June 26, 2014 at 6:45 am #12167
  
  Stavros Pissadakis
  Participant
  
  Dear Optiwave FDTD Community,
  
  We would like to simulate the confinement loss over a wavelength range and the band structure of an all-solid photonic band gap fiber, where the fibre body is made from silica glass and the high refractive index inclusions are made from a silver doped phosphate glass with refractive index greater than 1.8. We have bought the OptiFDTD V.8 64bit version sometime ago, but it is not very obvious to us how we can make this over a wavelength range these calculations. Any help would be much appreciated since we are in the middle of a manuscript submission process.
  
  Best regards,
  
  SP
- June 30, 2014 at 10:14 am #12202
  
  Damian Marek
  Participant
  
  Hi Stavros,
  
  It might be slightly different in OptiFDTD 8, but you can look at the tutorial on band gap simulations at:
  
  FCC Lattices of Air Spheres in Dielectric
  
  To perform a transmission vs wavelength type simulation, try a Gaussian Modulated Continuous Wave pulse as your input field. A very short pulse will have a large amount of frequency content. Then at the output place an Observation Area. Once the simulation is done, you can view the normalized (w.r.t Input Plane) Power detected as a function of wavelength. Again there is a tutorial that might make it clearer for you.
  
  Observation Points, Areas, and Lines
  
  Hope this helps!
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.