Base
Full Name | aya ayaa |
Organization | university |
Job Title | student |
Country |
Forum Replies Created
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
hi nuzhat dilawar
Thanks for your response.
regards
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
hi
Thanks alot, i think these links will be helpful,,
i will see them.
with regards
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
hi Karan
exactly this is what i want ,i write a matlab code depends on threshold value ,there no error during simulate in same time no any effect happened on power .
can u see it to me
i attache it
thax a lot and Apologies for any inconvenience.
Regards
Attachments:
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
thx alot ,i will see it
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
thx for help me, my problem is not in how to converte or calculate from wtts to dB , just when i run the code in matlab component there arn’t any error but still no change on output so i thought that the problem in the unit of parameter.
i want to design matlab component allow only to high power to pass and neglect the low power
best regard
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/9899/9fa9223242c9e0d4d7e5f477815adc3b-bpfull.jpg)
thanx alot for replying,
for the unit of input parameter in matlab code how can i select or change it to be dB
with reagrsd