Sweep Iteration - Optiwave

Free Evaluation

This topic has 3 replies, 2 voices, and was last updated 7 years ago by Mohamed A. A. Abouseif.

Viewing 3 reply threads

Author

Posts
- November 18, 2018 at 12:34 am #49937
  
  Alaa Abdellatif
  Participant
  
  Hello,
  While working on optisystem I have found the option of ‘SWEEP ITERATION’
  Please would you tell me what is the advantage of this option?
- November 19, 2018 at 9:15 am #49945
  
  Mohamed A. A. Abouseif
  Participant
  
  Hi Alaa,
  Sweep iteration is used to make the user able to run the program many times at different values of a component parameter.
  For example, if you choose your sweep iterator to be 10. Then that means you can choose to do the calculations 10 times and give any parameter of any component 10 values.
  
  I encourage you to check the following link for detailed description:
  
  Lesson 4: Parameter Sweeps — BER x Input Power
  
  Also, there are other lessons that might help you as an OptiSystem’s beginner-user to acquire the basics and the fundamentals and even to go deeply to the program.
  
  Hope that helps,
  thanks
  Mohamed Abouseif
- November 19, 2018 at 12:34 pm #49949
  
  Alaa Abdellatif
  Participant
  
  Yes, it was much helpful. Thank you for your reply Mr. Mohamed.
- November 19, 2018 at 12:54 pm #49951
  
  Mohamed A. A. Abouseif
  Participant
  
  Great,
  good luck
  Mohamed Abouseif
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.