Home Forums FIBER error when importing optifiber design in optisystem !!!

Viewing 7 reply threads
  • Author
    Posts
    • #16315
      mai fouad
      Participant

      when i design an optical fiber in optifiber and export profile , save it as .txt file and import this file to measured index fiber in optisystem and then run the project if give me this error :

      error in measured component : invalid input signal signal doesn’t have transverse modes .

      why did that happen and how to solve it ?

    • #16316
      mai fouad
      Participant

      i think that there is an error in loading the index profile txt file , but how to solve it ?

    • #16319
      Abdallah Ismail
      Participant

      Dear Ma
      Export your design as .data file then use this file in your measured fiber

    • #16320
      Abdallah Ismail
      Participant

      .dat

    • #16325
      mai fouad
      Participant

      I found this problem when i import my index profile either in .txt or .dat , it give me error in loading file , file is corrupted : here is the error and profile

    • #16327
      Abdallah Ismail
      Participant

      Ok please send me the files and I’ll check

    • #16342
      mai fouad
      Participant

      i catch the error , it was at transmitter that i used CW laser instead of spatial CW laser .

    • #16403
      Damian Marek
      Participant

      Try the procedure at the link below:

      Optisystem with optifiber

Viewing 7 reply threads
  • You must be logged in to reply to this topic.