September 5, 2023 at 8:56 am
#84792
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/23679/59945663b4165-bpfull.jpg)
Dear Manana,
Please note that you can’t load OptiSystem or Matlab files to the forum.
You need to make sure that the number of samples in the Matlab code and OptiSystem project match. You could make use up-sampling or down-sampling to achieve that. Also, you need to set the domain that is used for the calculation in the Matlab component correctly in field “Sampled signal domain” in the Main tab of the Matlab component properties window.
I hope these recommendations help.
Regards,
Ahmad
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)