March 13, 2023 at 3:53 pm
#83787
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/23679/59945663b4165-bpfull.jpg)
Dear Lana,
you need to increase the number of steps to allow reaching the desired tolerance during the optimization process. You could monitor the variation from step to step through the optimization tab in the calculation window. The graphs will help you to change the number of steps and the other parameters in the optimization process.
Regards,
Ahmad
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)