Home › Forums › SYSTEM › Determining Optimum Bandwidth for Low Pass Bessel Filters and Other Filters › Reply To: Determining Optimum Bandwidth for Low Pass Bessel Filters and Other Filters
February 6, 2023 at 12:00 pm
#81099
![Profile Photo](https://optiwave.com/wp-content/uploads/avatars/23679/59945663b4165-bpfull.jpg)
Dear Muhammad,
The 0.75 factor is a not carved in stone. You may change it around this value depending on the filter roll-off factor. You could always check the signal quality after the filter and decide.
Regards,
Ahmad
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)