Home › Forums › SYSTEM › not getting the output waveform for oqpsk example › Reply To: not getting the output waveform for oqpsk example
October 10, 2015 at 3:07 am
#26150

Hi Debanjan,
The reason for the simulation not showing any resluts at the receiving end is that the cut-off frequency of your quadrature demodulator is not matched with your bit rate and therefore, almost all the signal is filtered. I increased it to 0.75*bit rate and the results are there in the output. I am not sure about the validity of the system results, though.
Regards
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)