Home › Forums › SYSTEM › add/remove layout parameter › Reply To: add/remove layout parameter
October 8, 2015 at 3:36 am
#25980

A great part of my work deals with multiuser systems and it is hard to change the values of the components for the users one by one. Therefore, almost in all of my simulations, I add several parameters to the layout and I have always just needed to set the minimum value and maximum value. These are also the parameters you can remove later. So I suggest you don’t change the value for “Type” and “Category” and set the minimum and maximum values according to the minimum and maximum values you are going to give to thse corresponding parameter (it doesn’t need to be accurate; you can use a wider range).
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)