Home › Forums › GENERAL › software problem (to optiwave designers) › Reply To: software problem (to optiwave designers)
September 19, 2015 at 7:53 am
#24941

Two CW lasers have been used in your implementation. The “CW laser 1” whose spectrum should be shown in “Optical Spectrum Analyzer 8” shows no signal and that is due to the fact that there is no connection between the laser and the OSA. After I connected them, I was able to see the signal without problem. Please see if this is the case.
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)