Home › Forums › SYSTEM › Effect of Input power on Q factor and BER › Reply To: Effect of Input power on Q factor and BER
May 15, 2014 at 3:28 pm
#11593
I moved this to the System section, because the Knowledge section is reserved for moderators.
Generally the BER should improve as the input power is increased. However, there is a point at which nonlinear effects will significantly degrade the signal. On another note, perhaps the change in BER is very small. To resolve the small change try increasing the sequence length, which will increase the accuracy of the BER calculation.
Categories
- All
-
Knowledge
Contains a detailed Q&A knowledge base. -
General
All non-technical questions. -
System
Optical system design and analysis. -
Instrument
Communicate and control different kinds of instruments. -
SPICE
Opto-electronic circuit design. -
FDTD
Finite-Difference Time-Domain simulation. -
BPM
Beam Propagation Method analysis and design. -
Grating
Fiber optic grating simulation. -
Fiber
Optical fiber design and characterization. -
Exchange
Users can exchange design files.
(Matlab, C++, etc.)