Mode Division Multiplexers - Optiwave

Free Evaluation

This topic has 1 reply, 2 voices, and was last updated 3 years, 2 months ago by Amin Khorshidahmad.

Viewing 1 reply thread

Author

Posts
- February 28, 2021 at 6:11 am #68988
  SAUMENDRAKUMAR MOHAPATRA
  Participant
  Hello,
  I am trying to design a mode division mux using waveguide coupler module of optiGrating. How can I combine two wave guides in the single substrate. How it has been implemented in attached reference.
  Attachments:
  Grating-assisted-MDM-PDM-hybrid-demultiplexer-for-optical-interconnect-applications_2019.pdf
- March 1, 2021 at 11:33 am #69003
  
  Amin Khorshidahmad
  Participant
  
  Dear Saumendra,
  
  Thanks for your inquiry;
  
  In a waveguide coupler project, you may define the two waveguides, WG1 and WG2 (see the figure on page 144 of the OptiGrating Manual) each as a multi-layer slab structure. Please make sure the last region of WG1 and the first region of WG2 have exactly the same constant refractive index and the number of steps set to 1 for both; This forms the common layer for joining the two waveguides. The “distance” parameter in the “Waveguide Coupler Profile” tab sets the width of this common layer i.e., the distance between the waveguides. Note: the widths defined for the last region of WG1 and the first region of WG2 are both redundant.
  
  Kind regards,
  Amin
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.