BPM on topology-optimized WG - Optiwave

Free Evaluation

This topic has 1 reply, 2 voices, and was last updated 4 years, 3 months ago by Scott Newman.

Viewing 1 reply thread

Author

Posts
- August 3, 2020 at 9:46 am #67751
  
  mitsumasa nakajima
  Participant
  
  I want to use optiBPM for the validation of topology optimized circuit (see attached file).
  The question is following;
  
  (i)The name of >#10000 polygon is same
  -> Does it affect the results?
  (ii) The model is too heavy for GUI.
  -> Is there a way to solve this issue?
- August 3, 2020 at 9:49 am #67796
  
  Scott Newman
  Moderator
  
  Mitsumasa,
  
  The BPM algorithm has two limitations that must be taken into consideration when using it.1) It operates under the slowly varying approximation and as such the field and therefore the dielectric must be slowly varying, this does not appear to be the case in your design. 2) Special care must be taken when using high dielectric contrast. What are the refractive indices you are use?
  
  Are you able to provide me with information regarding the parameters of the domain, source, and size of the features?
  
  Over 10 thousand polygons is an extremely large number and there may not be a way around that., Also are you able to provide me with the dxf file?
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.