Simulation stops after a few seconds - Optiwave

Free Evaluation

This topic has 1 reply, 2 voices, and was last updated 5 years, 12 months ago by Mohamed A. A. Abouseif.

Viewing 1 reply thread

Author

Posts
- April 23, 2018 at 6:51 am #48607
  
  Rajandeep Singh
  Participant
  
  Hello everyone, I am working on the PON, for upstream i am using TWDM. The system works well for small number of ONUs (Few time slots), once I increase the number of time slots the simulation stops after a few seconds the Optisystem crashes and following error is displayed on the screen
  
  “A problem caused the program to stop working correctly. Windows will close the program & notify you if the solution is available”
  
  the screenshot is also attached. Please suggest me any possible cause
  In my view, following are the expected reasons for it.
  1. RAM of my PC which is 4GB is low for the setup.(I am going to upgrade RAM and will test again)
  2. There is a problem in setting Sequence length, Time window, Sample rate in global parameters
  Apart from it, Please suggest me possible cause and solution if any.
  Thanks
- May 3, 2018 at 9:10 am #48735
  
  Mohamed A. A. Abouseif
  Participant
  
  try to run it in another station with bigger RAM to check the first point.
  if the problem is still there, in setting increase the sequence length and check the effect. Do this increasing step by step and do not jump to high number of slots to be able to trace the reason.
  
  thanks
  Mohamed
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.