Setting Simulation Parameters

Compatibility:

Set the simulation parameters from Solving >> Solver Parameters to get the SolverĀ Parameters dialog box. In the General tab make the following entries

Step Action
1 Set Wavelength to 1.15
2 Select the Real Solver
3 Select Straight Waveguide
4 Select Semi-Vector TE for Mode
5 Set Number of Points in Mesh to be 151 for both X and Y
6 Select Number of Modes as 1
7 Donā€™t select Use Script
8 Click OK

Once the parameters have been set, the mode can be found from Solving >> SolveĀ ADI

BPM - Figure 7 Guided Mode of Ridge Waveguide

Figure 7: Guided Mode of Ridge Waveguide

When the mode solving is finished, youā€™ll be asked if you want to proceed to the Analyzer, If so, the simulator will close and the Analyzer application for this project will open.