To run the simulation, perform the following procedure.
|1||From the Simulation menu, select Additional Output Data.|
The Additional Output Data dialog box appears.
|2||Click the 2D tab.|
|3||Select the Power Overlap Integral check box.|
The Normalization and Overlap Integral With are selected automatically.
|4||Select the Power In Output Waveguides check box.|
The Normalization and Output Type are selected automatically (see Figure 9)
Figure 9: Selections in Additional Output Data dialog box
|5||To apply the settings and return to the layout window, click OK.|
|6||Re-save the project.|
|7||From the Simulation menu, select Calculate 2D Isotropic Simulation.|
|8||Ensure that the wavelength is 1.55µm.|
|9||To start the simulation, click Run.|
OptiBPM_Simulator opens and the simulation starts to run.
Note: At the end of the simulation, a prompt box appears. Do NOT open