Forum Replies Created

    #61444
    Profile Photo
    muhammad jawad
    Participant

    You may find the simulation file .osd in introductory tutorials as well.
    regards

    #60290
    Profile Photo
    muhammad jawad
    Participant

    Dear Mohammad
    If you are using an older evaluation version than optisystems 16 e.g optisystem 14, then download a newer version like 15 or 16 and your project file will be opened in both of these versions i.e 15 and 16

    regards

    #60289
    Profile Photo
    muhammad jawad
    Participant

    I also also understand that Mr Adnan is asking about how to design logic gates using nonlinear effects. The answer of Sir Ahmad is appropriate. For instance, an all-optical inverter is easily can be implemented using XGM in SOA. A lot of literature can be found easily using digital libraries.
    regards

    #60088
    Profile Photo
    muhammad jawad
    Participant

    Dear sir,
    i have sent the project file at your email address. Looking forward something great as before

    regards

    #59694
    Profile Photo
    muhammad jawad
    Participant

    Dear Josh

    Thanks for imparting good relevant information regarding chaotic laser. Can we have your email address.?
    regards

    #56072
    Profile Photo
    muhammad jawad
    Participant

    ok sir thanks

    #55956
    Profile Photo
    muhammad jawad
    Participant

    Sir i have drawn a LI curve at 1 Gbps data, Modulation peak current =10mA, Bias current sweeps from 0 to 25mA. I gets a circular type curve as shown in Fig attached. How to get a linear straight curve like DML laser so that VCSEL can be biased at middle of this linear region?

    Attachments:
    #55953
    Profile Photo
    muhammad jawad
    Participant

    Please sir tell me, in order to operate VCSELs like DMLs, we have to find its LI characteristics curve and then bias it at the half of the middle point of the LI curve?

    #54295
    Profile Photo
    muhammad jawad
    Participant

    Dear Sir

    Thanks for your reply. As i have worked over optical communication over multimode fiber (MMF), i just need to know how to mathematically write LP modes in MMF. The optiwave tutorials well explain working over MMF but not give required information. If you have relevant literature, do share with me sir.
    I will be very thankful
    Regards

    #53986
    Profile Photo
    muhammad jawad
    Participant

    Thanks Sir

    #53984
    Profile Photo
    muhammad jawad
    Participant

    Thanks Sir

    #52600
    Profile Photo
    muhammad jawad
    Participant

    Thnx sir ahmad

    #51914
    Profile Photo
    muhammad jawad
    Participant

    ok sir thanks for everything

    #51912
    Profile Photo
    muhammad jawad
    Participant

    thanks sir, i understood it fully

    #51860
    Profile Photo
    muhammad jawad
    Participant

    If PRBS is set at 10Gbps with Probability checked, then what will be selection of clock at DEMUX side?